Menu

Care and Handling

Crown Performance Panels are quality plywood panels designed to provide the maximum number of re-uses as possible.  In order to achieve the full potential for these products, the following minimum care and handling procedures are required:

Crown Performance Panels need to be stored flat, on a dry, well drained, level platform, under shelter and otherwise protected.  Steel straps should be cut and the forming surface of the top panel covered.  Avoid exposure of the panel surface to direct sunlight and rain, to minimize surface degradation.  Ensure panels are properly cleaned prior to stacking or storage.

Crown Performance Panels can be readily worked, with good quality hand or power tools (carbide tipped saw blades are recommended).  Panels should be fixed to forming members with screws.  If concrete appearance is a factor, screws should be countersunk and filled.  Panel joint leakage or details can be reduced by filling joints with a suitable sealant between panel edges (please consult your sealant supplier for the proper product for your application).  While panels are edge sealed at the factory, any field cuts or holes that expose wood need to be resealed with a minimum of two coats of high quality polyurethane varnish to reduce moisture absorption.

Crown Performance Panels are factory coated with Nox-Crete water based chemically active release agent.  The use of Nox-Crete release agents is recommended, and with high alkaline mixes, your release agent supplier can suggest a proper range of release agents for improved form life span.  Before first use, and after each pour, an equivalent chemically active release agent must be applied.  Do not use any form release agents that contain diesel fuel, solvents or engine oil.  These will degrade the overlay surface and will affect performance.

Crown Performance Panels are resistant to abrasion and impact.  However, as with any surface, it can be damaged through improper use.  The rate of pour and slump factor of the concrete must be limited to that assumed in the design of the form.  To minimize form damage, rubber tipped vibrators are recommended and should be used for consolidation only.  Vibrators should never be used for moving concrete horizontally in the forms.

With proper release treatment, stripping forms is easy.  Do not force panels with metal pry bars, or allow panels to be dropped and mis-handled.  The use of wooden wedges is recommended to loosen panels.  Clean panels right after stripping prior to the hardening of residue.   Use non-scratching tools such as stiff non-metallic brushes and plastic or wood scrapers.  Once cleaned, remove all nails and screws, re-oil panels, and stack face to face to prevent rapid drying of the wood and overlay surface.

Westlam Claim Policy: Prolonged exposure to damaging environmental elements, and improper care and maintenance of Westlam’s Crown Performance Panels may result in the degradation of the panel’s integrity and premature failure. It is the policy of Westlam Industries to replace the defective panel(s) or to reimburse the purchased price (at Westlam’s discretion).

 

Concrete Forming Design / Construction Guide

Damaged panels need to always be appropriately repaired prior to re-use. For further instructions please see APA’s Concrete Forming Design / Construction Guide